![]() Generate Board Edge Rout Paths – check this option to create a separate NC Rout file to define the board shape, including board cutouts.Use drilled slot command (G85) – check this option to use multiple drilled holes to create slots.Generate separate NC Drill files for VIA features – check this option to create separate drill files for each IPC 4761 via type.Generate separate NC Drill files for plated & non-plated holes – check this option to create separate drill files for plated and unplated holes.Optimize change location commands – check this option to optimize any change location commands.Reference to relative origin – use the relative origin as the reference point.Reference to absolute origin – use the absolute origin as the reference point. ![]() Suppress trailing zeroes – if this option is enabled, no trailing zeroes will appear in the generated NC Drill file.Suppress leading zeroes – if this option is enabled, no leading zeroes will appear in the generated NC Drill file.Keep leading and trailing zeroes – if this option is enabled, all leading and trailing zeroes will appear in the generated NC Drill file.Leading/Trailing Zeroes – zero suppression is a technique that reduces the size of the generated data files by removing all zeroes from the start (leading) or end (trailing) of numbers.The 4:3 and 4:4 formats only need to be chosen if there are holes on a grid finer than 1 mil. If you are using one of the higher resolutions, check that the PCB manufacturer supports that format.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |